What is the material required for these end caps?

Virgin polyethylene compound conforming to designations specified in IS 7328, such as PE-WA-50-T006 (for PE 80).

What is the required color of the fitting?

The fitting must be black. Any other color requires agreement between the purchaser and manufacturer (Clause 4.3).

What is the main performance test for these fittings?

A hydrostatic pressure test where the fitting must not rupture under specified stress, temperature, and duration as per Table 2.

Are there specific dimensional checks required?

Yes, dimensions such as spigot outside diameter and wall thickness must comply with the values given in Table 1.

IS 8008

: 2000

Injection Moulded/Machined High-Density Polyethylene (HDPE) Fittings for Potable Water Supplies, Part 1: General Requirements for Fittings

CurrentFrequently UsedSpecificationWater Resources · Plastic Piping System

Download PDF BIS Portal Google

🧮

Concrete Mix Design Calculator

Design your M20–M50 mix as per IS 10262 · Free tool

Calculate →

This standard (Part 1) specifies general requirements for injection-moulded High-Density Polyethylene (HDPE) fittings for potable water supply networks. It covers the material properties, colour, dimensions, performance tests like pressure tests and reversion, and marking requirements. These fittings are intended for use with HDPE pipes conforming to IS 4984.

Injection Moulded/Machined High-Density Polyethylene (HDPE) Fittings for Potable Water Supplies, Part 1: General Requirements for Fittings

Quick Reference Values

Material Density Minimum0.940 g/cm³ at 27°C

Melt Flow Rate (MFR) Tolerance±20% of the value specified for the raw material

Oven Test Temperature110 ± 2 °C

Hydrostatic Stress for PE 80 at 80°C for 165h test4.0 MPa

Colour of FittingBlack

Practical Notes

Ensure the HDPE material grade of the end cap (e.g., PE 80, PE 100) matches the grade of the pipe it is being fused to for a reliable joint.

Proper fusion welding (butt fusion or electrofusion) is critical; this standard only covers the fitting itself, not the jointing procedure.

The standard covers both injection-moulded fittings and fittings machined from extruded bar stock.